CAR-REP · Automotive
Car lock repair & replacement in Pine Castle, FL
A door lock that spins without locking, a trunk cylinder gone stiff, an ignition that grinds — vehicle lock hardware is repairable far more often than a service department suggests. We repair first and replace only when the part is finished.
Answered by the locksmith, not a call center · Open Mon–Sun · 8:00–22:00
What’s included
- Worn door cylinders restored — wafers re-fitted, springs and clips replaced — before replacement even comes up.
- Full assemblies swapped only when the housing is genuinely finished, and keyed to your existing key where the model allows.
- Vehicle rekeying per cylinder — one key across doors, trunk and ignition on older vehicles where the hardware agrees.
- Commuter sedans and airport-shift vehicles around the Sky Lake and Oak Ridge corridors — door cylinders that work twice a day take wear we know well.
- Proof of ownership required for any vehicle lock work — the same rule as keys, protecting you first.
What moves the price
- Cylinder repair versus full assembly — the difference is parts cost, not labor.
- Make and model: common fleet and commuter brands are stocked; some import cylinders are ordered and quoted honestly as such.
- Whether the ignition is involved — column hardware is a different job from door panels.
Priced per job: door cylinders from $80, full assemblies from $130, ignition work from $100, vehicle rekeying $70–$120 per cylinder. Both numbers — repair and replace — before anything starts.
| Job | Typical range |
|---|---|
| Car door lock cylinder repair (standard wafers) | $80–$150 |
| Full door lock assembly replacement | $130–$250 |
| Trunk lock cylinder servicing & pinning | $90–$160 |
| Ignition cylinder lock repair | $100–$180 |
| Vehicle rekeying (per cylinder) | $70–$120 |
Before you call
Quick answers
Repair or replace — how do you decide on a car lock?
The same honest rule as house locks: if the cylinder re-pins or swaps worn internals, that’s the better call. Replacement only when the housing is finished — and you hear both numbers first.
The door lock spins but never engages. Fixable?
Yes — typically a worn wafer stack or a broken actuator clip inside the cylinder. On most makes it’s a van repair, not a part order.
Can the replacement cylinder use my existing key?
On common vehicles, yes — the new cylinder pins to your current key so the truck or sedan doesn’t end up with two keys.
Is ignition work locksmith territory?
Sticky or jamming ignitions are lock work, done in the van. If the fault turns out to be column electronics beyond the lock, we say so and point you to the right shop — no guessing billed as work.
Do you work where the vehicle sits?
Yes — driveways off Orange Avenue, the Trail-side plazas, the Oak Ridge Road lots. Mobile is the whole model.
Lock misbehaving?
Say what it does — the job and the number come back on the phone.
MON–SUN · 8:00–22:00